D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
980
Format
config snmp system_location {<sw_location>}
Parameters
system_location - A maximum of 128 characters is allowed. And NULL string is accepted
<sw_location> - (Optional) Enter the system location string here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the Switch location for “HQ 5F”:
DGS-3120-24TC:admin# config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DGS-3120-24TC:admin#
101-25 config snmp system_contact
Description
This command is used to enter the name of a contact person who is responsible for the Switch.
Format
config snmp system_contact {<sw_contact>}
Parameters
system_contact - A maximum of 128 characters is allowed. And NULL string is accepted.
<sw_contact> - (Optional) Enter the system contact string here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the Switch contact to “MIS Department II”:
DGS-3120-24TC:admin# config snmp system_contact "MIS Department II"
Command: config snmp system_contact "MIS Department II"
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)