Emotron VS10 - Page 271

Parameter
Name / value range / [default setting]
Info
0x2441:007
WLAN settings: WLAN SSID
["c05x"]
From version 02.00
Name (Service Set Identifier, SSID) of the WLAN network.
The preset name consists of the device name (iXXX) and the first 10
digits of the serial number.
•
Example: "c051_0123456789"
The serial number is displayed in 0x2000:002 (P190.02).
0x2441:008
WLAN settings: WLAN password
["password"]
From version 02.00
Password (WLAN network key) of the WLAN network.
This password serves to secure the WLAN connections.
The password must have a minimum length of 8 digits.
Note!
If the WLAN module is to be plugged onto the inverter for a longer
period of time, it is important to select a safe password. Otherwise, a
potential attacker might connect to the WLAN access point and attack
the device and other connected devices or networks.
Currently (status: 2016), a WLAN is considered as safe if the password
consists of more than 20 characters,
contains capital and small letters, numbers and special characters and
cannot be found in any dictionary.
0x2441:009
WLAN settings: WLAN security
From version 02.00
Selection of the WLAN encryption.
0
WPA
1 WPA2
0x2441:010
WLAN settings: WLAN access
From version 02.00
Switch on/off WLAN.
0
Disabled (WLAN off)
1
Enabled (WLAN on)
0x2441:011
WLAN settings: WLAN channel
From version 02.00
Selection of the WLAN channel.
1
Channel 1
2
Channel 2
3
Channel 3
4
Channel 4
5 Channel 5
6
Channel 6
7
Channel 7
8
Channel 8
9
Channel 9
10 Channel 10
11
Channel 11
0x2441:012
WLAN settings: WLAN SSID broadcast
From version 02.00
1 = the name of the WLAN network, called SSID, is not visible for other
WLAN devices.
0 Activated
1
Deactivated
0x2442:004
Active WLAN settings: Active module mode
Read only
From version 02.00
Display of the active data source for the WLAN settings.
This parameter indicates whether the settings used come from the
inverter or from the WLAN module.
0
Inverter
The WLAN settings saved in the inverter are used.
1
Standalone
The WLAN settings saved in the WLAN module are used.
0x2442:005
Active WLAN settings: MAC address
Read only
From version 02.00
Display of the MAC address of the WLAN module.
0x2449
WLAN error
Read only
From version 02.00
Bit coded display of WLAN errors.
Bit 2
WLAN error
Bit 3
Memory problem
Bit 4
WLAN connection problem
Bit 7
WLAN off
Bit 9 Client mode off