Emotron VS10 - Resetting WLAN Settings to Default Setting

272 01-6203-01R3, CG Drives & Automation
Parameter
Name / value range / [default setting]
Info
Bit 12
TCP/IP configuration error
Bit 13 Password length
Bit 14
Access denied
10.3.2.1. Resetting WLAN settings to default setting
Possible reasons:
• Password is not known anymore.
• WLAN SSID is not visible and not known anymore.
• WLAN module mode "stand-alone" shall be deactivated.
0x2440 serves to reset all WLAN settings to the default setting. For this purpose, the
inverter must be connected to the »Emotron Easy starter« via the USB module or an
existing network.
Option 1: Reset via USB module
How to reset the WLAN settings to default setting by means of the USB module:
Requirements:
• The inverter is ready for operation (supplied with voltage).
Required accessories:
• USB module
• USB 2.0 cable (A-plug on micro B-plug)
• PC with installed »Emotron Easy starter« software
1. Remove the WLAN module from the inverter and plug on the USB module instead.
2. Establish a connection between inverter and »Emotron Easy starter« via the USB
module.
3. Set the parameter 0x2440 to "Restart with default values [2]".
4. Remove the USB module from the inverter and plug on the WLAN module instead
again.
The default setting is loaded.
Option 2: Reset via network
How to reset the WLAN settings to default setting via network:
Requirements:
• The inverter is ready for operation (supplied with voltage).
• The inverter is connected to a functioning network.
Required accessories:
• PC with installed »Emotron Easy starter«. Moreover, the PC must be connected to the
network which also implements the inverter.
1. Establish a connection between the inverter and »Emotron Easy starter« via the used
network.
2. Set the parameter 0x2440 to "Restart with default values [2]".
The default setting is loaded.