Emotron VS10 - Parameter for Engineering Tools

340 01-6203-01R3, CG Drives & Automation
10.19. Parameter for engineering tools
The following parameters are required for an interaction of the engineering tools with the
inverter connected online. They are not relevant for the user and only reported here for
the sake of completeness.
Parameter
Name / value range / [default setting]
Info
0x2022:032
Device commands: Deactivate PDO Communication
From version 03.00
For further possible settings, see parameter
0x2022:001 (P700.01).

242
Parameters for interaction with engineering tools.
0
Off / ready
Only status feedback
0x2022:033
Device commands: Activate PDO Communication
For further possible settings, see parameter
0x2022:001 (P700.01).

242
Parameters for interaction with engineering tools.
0 Off / ready Only status feedback
0x2822:001
Enable inverter
Parameters for interaction with engineering tools.
0
Inverter inhibited
1
Inverter enabled
0x2822:002
Activate quick stop
0 ... [0] ... 1
0x2822:003
Reset error
0 ... [0] ... 1
0x2822:028
Initialize device controller
0 ... [0] ... 1
0x2823:001 Last subindex
Read only
0x2823:002
Status of last axis command
Read only
0
Successful
1
Unknown command
2
No access
3
Time-out
4
Error
5
Command server assigned
6
Disable inverter required
7
Enable inverter required
8
Command is executed
10
Memory module link invalid
11
Password too short
12
Wrong password
13
Password set
14
Password assigned
15
Command aborted
0x2832
Motor identification status
Read only
From version 02.00
Bit 0
Identification enabled
Bit 1
Identification active
Bit 2
Identification completed
Bit 3
Identification failed
0x2DB8:001 Function list status word 1
Read only
From version 04.00
Bit 0 Enable inverter
Bit 1
Run
Bit 2
Activate quick stop