Emotron VS10 - Keypad Setpoint Default Setting

6.3.1. Keypad setpoint default setting
For the manual setpoint selection via keypad the following default settings are used.
Parameter
Name / value range / [default setting]
Info
0x2601:001
(P202.01)
Keypad setpoints: Frequency setpoint
(Keypad setpoints: KP freq.setpoint)
0.0 ... [20.0] ... 599.0 Hz
Default setting of the keypad setpoint for the operating mode 0x6060
(P301.00) = "MS: Velocity mode [-2]".
0x2601:002
(P202.02)
Keypad setpoints: Process controller setpoint
(Keypad setpoints: KP PID setpoint)
-300.00 ... [0.00] ... 300.00 PID unit
Default setting of the keypad setpoint for the reference value of the PID
control.
0x2601:003
(P202.03)
Keypad setpoints: Torque setpoint
(Keypad setpoints: KP torq.setpoint)
-400.0 ... [100.0] ... 400.0 %
From version 03.00
Default setting of the keypad setpoint for the operating mode 0x6060
(P301.00) = "MS: Torque mode [-1]".
100 % ≡ Motor rated torque 0x6076 (P325.00)
The increment for keypad setpoints can be adapted in 0x2862 (P701.00) by pressing a
keypad arrow key once.