Emotron VS10 - Generate a Connection between Inverter and Emotron Easy Starter

4.2.2.1. Generate a connection between inverter and »Emotron Easy starter«
For commissioning the inverter with the »Emotron Easy starter«, a communication link
with the inverter is required. This can be established in a wired or wireless manner via
WLAN.
Preconditions
• For the wired communication with the inverter, the USB module and a USB 2.0 cable (A
plug on Micro-B plug) are required.
• For the wireless communication with the inverter, the WLAN module is required.
Moreover, the PC on which the »Emotron Easy starter« is installed must be wireless-
enabled.