Emotron VS10 - Page 341

Parameter
Name / value range / [default setting]
Info
Bit 3
Reset fault
Bit 4 Activate DC braking
Bit 5
Start forward (CW)
Bit 6
Start reverse (CCW)
Bit 7
Run forward (CW)
Bit 8
Run reverse (CCW)
Bit 9 Jog foward (CW)
Bit 10
Jog reverse (CCW)
Bit 11
Activate keypad control
Bit 12
Invert rotation
Bit 13
Activate AI1 setpoint
Bit 14 Activate AI2 setpoint
Bit 15
Activate keypad setpoint
Bit 16
Activate network setpoint
Bit 17
Activate preset (bit 0)
Bit 18
Activate preset (bit 1)
Bit 19 Activate preset (bit 2)
Bit 20
Activate preset (bit 3)
Bit 21
Activate setpoint via HTL input
Bit 22
MOP setpoint up
Bit 23
MOP setpoint down
Bit 24 Activate MOP setpoint
Bit 25
Activate segment 1 setpoint
Bit 26
Activate segment 2 setpoint
Bit 27
Activate segment 3 setpoint
Bit 28
Activate segment 4 setpoint
Bit 29 Activate sequencer setpoint
Bit 30
Start sequencer
Bit 31
Next sequence step
0x2DB8:002
Function list status word 2
Read only
From version 04.00
Bit 0
Pause sequence
Bit 1
Suspend sequence
Bit 2 Stop sequence
Bit 3
Abort sequence
Bit 4
Activate network control
Bit 5
Deactivate network control
Bit 6
Activate ramp 2
Bit 7 Load parameter set
Bit 8
Select parameter set (bit 0)
Bit 9
Select parameter set (bit 1)
Bit 10
Activate fault 1
Bit 11
Activate fault 2
Bit 12 Deactivate PID controlling
Bit 13
Set PID output to 0
Bit 14
Inhibit PID I-component
Bit 15
Activate PID influence ramp
Bit 16
Release holding brake