Emotron VS10 - Page 277

Parameter
Name / value range / [default setting]
Info
0x2441:001
WLAN settings: IP address
0 ... [28485824] ... 4294967295
From version 02.00
Definition of the IP address for the WLAN access point.
In the client mode, a static IP address can be set here for the WLAN
client. In order that the static configuration becomes effective, DHCP
must be disabled in 0x2441:004.
Byte order is "Big-Endian":
192.168.178.01 ≡ 0x01B2A8C0 (= 28485824)
0x2441:002
WLAN settings: Netmask
0 ... [16777215] ... 4294967295
From version 02.00
Definition of the network mask for the WLAN access point.
In the client mode, a static network mask can be set here for the
WLAN
client. In order that the static configuration becomes effective, DHCP
must be disabled in 0x2441:004.
Byte order is "Big-Endian":
255.255.255.0 ≡ 0x00FFFFFF (= 16777215)
0x2441:003
WLAN settings: Gateway
0 ... [28485824] ... 4294967295
From version 02.00
Definition of the gateway for the WLAN access point.
In the client mode, a static gateway can be set here for the WLAN
cli
ent. In order that the static configuration becomes effective,
DHCP must be disabled in 0x2441:004.
Byte order is "Big-Endian":
192.168.178.1 ≡ 0x01B2A8C0 (= 28485824)
0x2442:001
Active WLAN settings: Active IP address
Read only
From version 02.00
Display of the active IP address.
If DHCP is activated, the active IP address usually derives from the
configured static IP address of the device.
0x2442:002
Active WLAN settings: Active netmask
Read only
From version 02.00
Display of the active netmask.
0x2442:003
Active WLAN settings: Active gateway
Read only
From version 02.00
Display of the active gateway IP address.
0x2448:001
WLAN status: Connection time
Read only
From version 02.00
Display of the connection time in [s] since the current connection was
established.
0x2448:002
WLAN status: Number of connections
Read only
From version 02.00
In access point mode: Display of the number of currently connected
clients.
In client mode: 0 ≡ not connected; 1 ≡ connected with external WLAN
network.
0x2448:003
WLAN status: Rx frame counter
Read only
From version 02.00
Display of the number of request received via WLAN.
0x2448:004
WLAN status: Error statistics
Read only
From version 02.00
Display of the quality of the WLAN connection. A display value > 0
indicates communication problemsn.