416 01-6203-01R3, CG Drives & Automation
The following signal flow illustrates the reset of an error both with the "Reset error"
function
②
and by cancelling the start command
④
:
① If an error condition is active in the inverter, the motor is brought to a standstill
with the quick stop ramp. The inverter is then disabled.
Exception: In case of a serious error, the inverter is disabled immediately. The
motor becomes torqueless (coasts).
② If the error can be reset, the error state can be left again with the "Reset fault"
function (if the error condition no longer exists). The motor accelerates again to the
setpoint since the start command is still active.
③ The functions "Activate fault 1" and "Activate fault 2" serve to set the inverter from
the process to the error status.
④ If the error can be reset, the cancelled start command results in leaving the error
state (if the error condition no longer exists).
Related topics
Error handling
84
To Next Page
