Epson EPL-N3000 - Page 402

EPSON EPL-N3000/AcuLaser M4000N Revision C
Adjustment Firmware Update 402
Confidential
MAIN CONTROLLER FIRMWARE UPDATE
Procedure
Method 1 Method 2
(RCC) (CRB)
1 Check the current firmware version Print a status sheet, and check the current firmware version. Print a status sheet, and check the current firmware version.
2 Connect the printer to the computer
Connect the printer to the computer with a USB cable.
Confirm that “Ready” is displayed on the LCD panel.
Turn off both the printer and the computer, and connect them with a USB
cable.
Before connecting the USB cable, make sure to disconnect other
interface cables from the product.
3 Prepare the firmware data file
Turn the computer on, copy the firmware data file (extension: RCC), and
save it onto the computer.
Turn the computer on, copy the firmware data file (extension: CRB), and
save it onto the computer.
4 Start up the printer
---
Hold down [Start/Stop] + [Cancel Job] + [ ] and turn the printer on. The
printer will start up in “Program ROM update” mode.
5
Prepare to transmit the file
Run the Firmware Update Tool.
Select the port and firmware data file on the Firmware Update Tool
window.
Run the Firmware Update Tool.
Select the port and firmware data file on the Firmware Update Tool
window.
6 Transmit the data
Click [Send] on the Firmware Update Tool window. Click [Send] on the Firmware Update Tool window.
C A U T I O N