Epson EPL-N3000 - LVPS (Aculaser M4000 N)

EPSON EPL-N3000/AcuLaser M4000N Revision C
Disassembly and Assembly AcuLaser M4000N Unique Disassembly Procedures 390
Confidential
4.14.7 LVPS (AcuLaser M4000N)
Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR (AcuLaser M4000N). (p.379)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the 500 EXIT ASSY. (p.262)
7. Remove the COVER TOP, CONTROL PANEL (AcuLaser M4000N). (p.380)
8. Remove the COVER FRONT. (p.172)
9. Remove the SHIELD PLATE LVPS.
10. Disconnect the harness connector of the LVPS from the connector (P/J101) of the
PWBA EXIT MOTOR.
11. Disconnect the harness connectors from the connectors (P/J40, P/J41, P/J42, P/
J43, P/J44, P/J45, P/J46, P/J47, P/J48) of the LVPS.
12. Remove the five screws (silver, 6mm) securing the LVPS to the frame.
13. Remove the LVPS.
Figure 4- 180. LVPS Removal
J23177EA
PWBA EXIT MOTOR
LVPS
LVPS
P/J45
P/J42
P/J43
P/J44
P/J46 P/J40P/J41
P/J47
P/J48
13)
12)
11)