Epson EPL-N3000 - Writing USB ID

EPSON EPL-N3000/AcuLaser M4000N Revision C
Adjustment Adjustment 399
Confidential
5.2.2 Writing USB ID
PURPOSE
EPL-N3000/AcuLaser M4000N comes with the USB interface as a standard, and the
computer connected to the EPL-N3000/AcuLaser M4000N via the USB interface
identifies the printer by referring to the USB ID information unique to each printer.
Since this USB ID information is stored on EEPROM on the main board of the printer,
you have to re-define the ID information by following the procedure described below
after replacing the main board for repair.
TOOL
The program required for writing USB ID and the system requirements are as follows:
 Program
PPInitSetting_Ver1x E.exe
 System requirements
 OS
Windows 95/98/ME/2000/XP
 Port used
LPT, USB
INSTALLATION AND THE OPERATION OF THE PROGRAM
1. Copy all the files related to "PPInitSetting" program and save them into one folder.
2. Double-click the program icon [ ] to start the program.
3. Select the model name from [Model Selection].
4. Select the port used to connect the printer from [Port Selection].
Figure 5- 1. Operation of the Program
C H E C K
P O I N T
Be sure to save a complete set of files related to "PPInitSetting"
program into one folder.
C H E C K
P O I N T
When you select "Auto selection", the computer automatically
detects the connected printers and starts communicating with the
one detected first. When two or more printers are connected,
specify the target port to avoid unexpected connection.