Epson EPL-N3000 - Roll Regi Rubber

EPSON EPL-N3000/AcuLaser M4000N Revision C
Disassembly and Assembly 150 Paper Feeder 217
Confidential
4.5.5 ROLL REGI RUBBER
Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the FUSER ASSY. (p.253)
3. Remove the COVER REAR. (p.167)
4. Remove the FAN MAIN. (p.293)
5. Remove the CHUTE TRANSFR. (p.255)
6. Remove the 150 FEEDER ASSY. (p.211)
7. Remove the two SPRINGs REGI mounted on the left and right of the 150
FEEDER ASSY and hitched on the CHUTE REGI and ROLL REGI RUBBER.
8. Remove the E ring securing the GEAR REGI RUBBER to the ROLL REGI
RUBBER, and remove the GEAR REGI RUBBER.
9. Remove the E ring securing the BEARING REGI LEFT to the ROLL REGI
RUBBER.
10. Draw out the BEARING REGI LEFT and turn, disengage the cut portion of the
BEARING REGI LEFT from the projection of the CHUTE REGI, and remove the
BEARING REGI LEFT from the ROLL REGI RUBBER. (NOTE 1)
11. Remove the E-ring retaining the CLUTCH REGI, and shift the CLUTCH REGI in
the direction of the arrow.
12. Draw out the BEARING REGI RIGHT and turn, disengage the cut portion of the
BEARING REGI RIGHT from the projection of the CHUTE REGI, and remove
the BEARING REGI RIGHT from the ROLL REGI RUBBER. (NOTE 1)
13. Move the ROLL REGI RUBBER as indicated by the arrow, and remove it from
the 150 FEEDER ASSY.
Figure 4- 43. ROLL REGI RUBBER Removal
C A U T I O N
In removal, take care not to hold any rubber portion of the ROLL
REGI RUBBER.
JG3034A
A
HOOK HOOK
BEARING REGI
RIGHT
BEARING REGI
LEFT
CLUTCH REGI
ROLL REGI RUBBER
D cut
GEAR REGI
SPRING REGI
8.7mm
10.1mm
SPRING REGI
SPRING REGI
SPRING REGI
HARNESS
ASSY TONER 2
Note 1) Note 1)Note 2)
12)
10)
8)
7)
13)
9)
11)