5.3 Normal Sweep
144
3
Sweep Range Setting
Select the setting method of the sweep range.
When you want to cancel the setting:
Press .
Sets the start value of the sweep and the step
width of sweep points.
Each sweep point is automatically calculated
from the number of sweep points.
開始値
幅
Sets the start value and end value of the sweep.
Each sweep point is automatically calculated
from the number of sweep points.
Start value End value
Number of sweep points
For details on the settings, refer to the following figures.
Sets the center value of the sweep range and
the sweep width.
Each sweep point is automatically calculated
from the number of sweep points.
Fixes the sweep parameter and performs mea-
surement at a set time interval.
Time interval
Number of sweep points
To Next Page
Loading...
Need help?
General
