Chapter 5 Configuring the Meter
Configure – Measure Tab
62 DSAM Help User Guide Rev. 001
2 Press the Measure softkey.
3 Using the arrow keys, select DOCSIS Throughput.
4 Press ENTER.
5 Using the arrow keys, select the parameter you want to edit.
6 Press ENTER.
Figure 51 Configure – Measure Tab: DOCSIS Throughput
Figure 52 Configure – DOCSIS Throughput
NOTE
The default values for the server IP address and file to be trans-
ferred are maintained by JDS Uniphase Corporation. For more
accurate results, JDS Uniphase Corporation recommends that you
set up your own throughput server close to your gateway.
21128026 R001 DSAM Help User Guide.book Page 62 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
