Chapter 7 AutoTest Mode
AutoTests Tab
DSAM Help User Guide Rev. 001 123
5 Using the arrow keys, select Channel Plan.
6 Press ENTER.
7 Using the arrow keys, select an option.
8 Press ENTER.
9 Using the arrow keys, select Limit Plan.
10 Press ENTER.
11 Using the arrow keys, select an option.
12 Press ENTER.
Figure 115 AutoTest – Video AutoTest
NOTE
To perform the test without checking the results against limit values,
select Off.
If you select Off as the Limit Plan value, no pass/fail information is
displayed in the test results.
NOTE
Use “Regional Preferences” on page 43 to specify the type of signal
level units and digital performance units to display.
Use “Limit Sets” on page 58 to edit limit set parameters to meet
your needs.
Use “Other Settings” on page 65 to define the best measurement
settings (such as DOCSIS settings) for your current work practices.
21128026 R001 DSAM Help User Guide.book Page 123 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
