Chapter 5 Configuring the Meter
Configure – General Tab
DSAM Help User Guide Rev. 001 47
Enabling/Disabling
Security Protection
To enable/disable security protection
1 Press Configure.
2 Press the General softkey.
3 Using the arrow keys, select Security.
4 Press ENTER.
5 Using the arrow keys, select Enable/disable security protec-
tion.
6 Press ENTER.
7 Press ENTER.
8 Using the arrow keys, select Enable or Disable.
9 Press ENTER.
10 Press the OK softkey.
Choose a Utility
Use the Choose a Utility screen to:
Clear All Files
This utility deletes all measurement files and channel plans currently
stored in your meter, including protected files.
Restore Factory
Defaults
This utility restores all configuration parameters to their factory-preset
values.
Reset Meter
This utility returns all parameters to the factory default values. It also
disables security protection and removes the existing personal identi-
fication number (PIN). Even protected files are affected.
To choose a utility
1 Press Configure.
2 Press the General softkey.
NOTE
The default setting for security is Disabled.
NOTE
Reset Meter deletes all measurement files and channel plans.
21128026 R001 DSAM Help User Guide.book Page 47 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
