Chapter 5 Configuring the Meter
Configure – General Tab
30 DSAM Help User Guide Rev. 001
5 To switch between contrast modes, press the Manual/Auto
softkey.
6 Adjust the degree of difference between the lightest and darkest
areas of the screen by using the left and right arrow keys to move
the contrast indicator (slider).
The Auto mode allows a limited amount of adjustment.
7 Press the Done softkey.
Sound
Use the Adjust Sounds screen to change the volume of sounds and
the sensitivity of the microphone.
Configuring Sounds
To configure sounds
1 Press Configure.
2 Press the General softkey.
Figure 14 Configure – Adjust Contrast
NOTE
When the Auto softkey is displayed, the DSAM contrast function is
in Manual mode and vice versa. The factory default mode is Auto.
NOTE
To perform a repetitive contrast adjustment, press and hold the left
or right arrow key.
21128026 R001 DSAM Help User Guide.book Page 30 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
