Chapter 7 AutoTest Mode
AutoTests Tab
124 DSAM Help User Guide Rev. 001
13 Press the Settings softkey.
14 To select Edit Test Point Compensation, press ENTER. (For
detailed instructions on choosing a TPC plan see page 71.)
15 Using the arrow keys, select a TPC plan.
16 Press the Done softkey.
17 Press the Start softkey.
The AutoTest in Progress screen is displayed.
The results appear on the Video AutoTest screen.
Figure 116 AutoTest – AutoTest in Progress
NOTE
The Help system is disabled during all tests while they are in prog-
ress.
To stop the test, press the Stop softkey.
NOTE
To save the results to a file, press the Save softkey then follow
step 4 through step 13 under “Saving Results” on page 198.
If you chose the wrong limit set before conducting the test, press
the Limits softkey and select a different limit set to view your test
results in relation to a different limit set without rerunning the test.
21128026 R001 DSAM Help User Guide.book Page 124 Thursday, February 5, 2009 2:02 PM