Chapter 7 AutoTest Mode
AutoTests Tab
138 DSAM Help User Guide Rev. 001
23 Press ENTER.
24 To run a single, immediate Proof of Performance test, press the
Immediate softkey, use the arrow keys to highlight the location
settings parameters then press the ENTER key, edit the entry,
then press the OK softkey.
OR
25 To schedule a sequential series of tests, press the Scheduled
softkey.
The Configure Scheduling screen is displayed.
26 Using the arrow keys, select Interval Between Tests (in
minutes).
27 Press ENTER.
28 Using the numeric keys, type the number of minutes between
when the meter shuts down after a test and when it starts up for
the next test.
29 Press ENTER.
30 Using the arrow keys, select Test Start Time.
31 Press ENTER.
32 Using the numeric keys, type the start time of the first test.
33 Press ENTER.
34 Using the arrow keys, select Test Start Date.
Figure 130 AutoTests – Configure Scheduling
21128026 R001 DSAM Help User Guide.book Page 138 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
