Chapter 7 AutoTest Mode
AutoTests Tab
122 DSAM Help User Guide Rev. 001
2 Press the View softkey.
3 Using the arrow keys, select DOCSIS Status.
4 Press ENTER.
Video Channels
Test
A Video Channels test is an automated test sequence designed to
assess the signal performance of a user-configured series of analog
and/or digital video channels. An RF plant that passes this test meets
the minimum requirements for the delivery of video services. When
necessary, you can troubleshoot an installation by performing this test
at various locations to determine which components require repair or
replacement. You can store the test results for later reference.
Running a Video
Channels Test
To run a video channels test
1 If necessary, configure the limit sets to meet your needs for tap,
ground block, TV, cable modem, proof, or custom limits 1-3.
2 Press the AutoTest button.
3 Using the arrow keys, select Video Channels.
4 Press ENTER.
Figure 114 AutoTest – Combo AutoTest: DOCSIS Status
NOTE
The limit set parameters you set remain constant for all channel
plans and measurement modes.
21128026 R001 DSAM Help User Guide.book Page 122 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
