Chapter 7 AutoTest Mode
AutoTests Tab
140 DSAM Help User Guide Rev. 001
OR
51 To use the default Location settings, press the Default softkey.
52 Using the arrow keys and the alphanumeric keypad, edit the
entry.
53 Press the OK softkey.
If you are running a series of scheduled Proof of Performance
tests, the Completed Test Statistics displays the number of passed
and failed tests in the series. The counts reset when you select a
new file name.
Once the first test in a series is complete, the meter shuts down
until the next scheduled test. If you attempt to power up the meter
while it is running a series of Proof of Performance tests, it
prompts you to cancel the test or resume by powering the meter
down until the next scheduled test. After the last scheduled test,
the meter does not power down.
Figure 132 AutoTest – AutoTest in Progress
NOTE
The Help system on this meter is disabled during all tests while they
are in progress.
To stop the test, press the Stop softkey.
21128026 R001 DSAM Help User Guide.book Page 140 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
