Chapter 9 Measure Mode – Service Tab
CM Diagnostics Page
232 DSAM Help User Guide Rev. 001
Deleting Ping IP
Addresses
To delete an IP address
1 Using the arrow keys, select the IP Address option.
2 Press ENTER.
3 Using the arrow keys, select the IP address you want to delete.
4 Press ENTER.
5 Press the Settings softkey.
6 Using the arrow keys, select Delete IP.
7 Press ENTER.
CM Diagnostics Page
The CM Diagnostics mode (additional purchase required) is based on
the Ethernet network configuration. The cable modem should be
connected to the RF network. The DSAM must be connected to the
cable modem through an Ethernet port.
The CM Diagnostics screen should display the cable modem's internal
web page. This indicates that the cable modem is connected to your
local CMTS and functioning properly.
Testing CM
Diagnostics
To test CM Diagnostics
1 Press Measure.
2 Press the Service softkey.
NOTE
The last edited IP address is placed on the top of the option list.
21128026 R001 DSAM Help User Guide.book Page 232 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
