JDS Uniphase DSAM-3600 - Displaying IP Information; Figure 201 Measure Mode - Service Tab: Ethernet

Chapter 9 Measure Mode – Service Tab
Ethernet
226 DSAM Help User Guide Rev. 001
Displaying IP
Information
To display IP information
1 Press Measure.
2 Press the Service softkey.
3 Using the arrow keys, select Ethernet.
4 Press ENTER.
When the IP connection activity is complete, the Bind Results
screen is displayed with detailed results.
NOTE
To save the results to a file, refer to “Saving Results” on page 198.
You can terminate the Ethernet test process at any time by pressing
the Cancel softkey.
Figure 201 Measure Mode – Service Tab: Ethernet
21128026 R001 DSAM Help User Guide.book Page 226 Thursday, February 5, 2009 2:02 PM