Chapter 8 Measure Mode – Basic Tab
Tilt
DSAM Help User Guide Rev. 001 169
1 Press Measure.
2 Press the Basic softkey.
3 Using the arrow keys, select Tilt.
4 Press ENTER.
Figure 153 Measure Mode – Basic Tab
N
NOTE
To save the results to a file, refer to “Saving Results” on page 198.
If no channels are enabled for tilt in the channel plan, an error mes-
sage is displayed.
If you chose the wrong limit set before conducting the test, press
the Limits softkey and select a different limit set to view your test
results in relation to a different limit set without rerunning the test.
21128026 R001 DSAM Help User Guide.book Page 169 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
