Chapter 7 AutoTest Mode
AutoTests Tab
136 DSAM Help User Guide Rev. 001
5 Using the arrow keys, select Channel Plan.
6 Press ENTER.
7 Using the arrow keys, select an option.
8 Press ENTER.
9 Using the arrow keys, select Limit Plan.
10 Press ENTER.
11 Using the arrow keys, select an option.
12 Press ENTER.
13 Using the arrow keys, select Filename to Save to.
14 Press ENTER.
Figure 129 AutoTest – Configure Proof of Performance
NOTE
To perform the test without checking the results against limit values,
select Off.
If you select Off as the limit plan value, no pass/fail information is
available in the test results.
21128026 R001 DSAM Help User Guide.book Page 136 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
