Chapter 5 Configuring the Meter
Configure – General Tab
DSAM Help User Guide Rev. 001 41
3 Using the arrow keys, select RF Network.
4 Press ENTER.
5 Using the arrow keys, select the parameter you want to edit.
6 Press ENTER.
7 Using the arrow keys and the alphanumeric keypad, edit the
value.
8 Press ENTER.
9 Press the OK softkey.
RF Network
Parameters
RF network parameters are the same as Ethernet parameters. Refer
to “Ethernet Settings Parameters” on page 40.
Figure 27 Configure – General Tab: RF Network
Figure 28 Configure – Configure RF Network
21128026 R001 DSAM Help User Guide.book Page 41 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
