Chapter 7 AutoTest Mode
AutoTests Tab
DSAM Help User Guide Rev. 001 127
5 Using the arrow keys, select the folder you want to work with.
6 Press the Open softkey or ENTER.
7 Using the arrow keys, select Channel Plan.
8 Press ENTER.
9 Using the arrow keys, select an option.
10 Press ENTER.
11 Using the arrow keys, select Limit Plan.
12 Press ENTER.
13 Using the arrow keys, select an option.
Figure 119 AutoTest – Work Folders
NOTE
Note the name of the folder in the Active Work Folder box. If the
folder name is incorrect, press the Back softkey and select a differ-
ent folder.
NOTE
To perform the test without checking the results against limit values,
choice Off.
If you select Off as the limit plan value, no pass/fail information is
available in the test results.
Data plans are deployed to the DSAM through TPP.
21128026 R001 DSAM Help User Guide.book Page 127 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
