Chapter 5 Configuring the Meter
Configure – General Tab
50 DSAM Help User Guide Rev. 001
11 Using the arrow keys, select receive settings from another
meter.
12 Press the Select softkey.
13 If cloning to multiple meters, attach the Ethernet cable to a
different meter and repeat.
Receiving Settings
To receive settings
1 Connect the meters via Ethernet cable.
The Ethernet port is located at the top of each meter. Use an
Ethernet crossover cable or a standard ethernet cable with a
crossover adapter to connect meters.
2 Press Configure.
3 Press the General softkey.
4 Using the arrow keys, select Clone.
5 Press ENTER.
6 Using the arrow keys, select receive settings from another
meter.
Diagnostic
Use the Diagnostic screen to test the keypad and/or connect to the
TPP network and control the DSAM from your computer.
Testing the Keypad
To test the keypad
1 Press Configure.
2 Press the General softkey.
21128026 R001 DSAM Help User Guide.book Page 50 Thursday, February 5, 2009 2:02 PM