Chapter 7 AutoTest Mode
AutoTests Tab
DSAM Help User Guide Rev. 001 129
Figure 120 AutoTest – Certification in Progress
NOTE
The Help system is disabled during all tests while they are in prog-
ress.
To stop the test, press the Stop softkey.
Figure 121 AutoTest – Home Certification
NOTE
To save the results to a file, press the Save softkey then follow
step 4 through step 13 under “Saving Results” on page 198.
If you chose the wrong limit set before conducting the test, press
the Limits softkey and select a different limit set to view your test
results in relation to a different limit set without rerunning the test.
21128026 R001 DSAM Help User Guide.book Page 129 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
