JDS Uniphase DSAM-3600 User Manual

Chapter 11 Measure Mode – Sweep Tab
Sweepless Sweep
DSAM Help User Guide Rev. 001 285
– Open File – Enables you to select and open a saved reverse
sweep measurement file.
– Clear Reference – Removes the reference file from measure-
ment and returns the subtitle bar to “REF: NONE.”
3 Press ENTER.
Sweepless Sweep
Sweepless Sweep (additional purchase may be required) enables you
to retrieve sweep information without a transmitter. Carrier levels
derived from the channel plan are measured and recorded to compare
with the levels of the same carriers at a different point in the network.
Running a
Sweepless Sweep
To run a sweepless sweep
1 Press Measure.
2 Press the Sweep softkey.
Figure 254 Measure Mode – Sweepless Sweep
21128026 R001 DSAM Help User Guide.book Page 285 Thursday, February 5, 2009 2:02 PM

JDS Uniphase DSAM-3600 Specifications

General

Brand	JDS Uniphase
Model	DSAM-3600
Category	Measuring Instruments
Language	English