Chapter 7 AutoTest Mode
AutoTests Tab
126 DSAM Help User Guide Rev. 001
Home
Certification Test
A Home Certification test (additional purchase required) is a user-
configured sequential combination of analog and digital video chan-
nels, as well as DOCSIS connectivity and data tests. (DOCSIS data
tests must be enabled through TPP.) The test configuration must be
deployed to the meter before you can run a Home Certification test.
Running a Home
Certification Test
To run a Home Certification test
1 If necessary, configure the limit sets to meet your needs for tap,
ground block, TV, cable modem, proof, or custom limits 1-3.
2 Press AutoTest.
3 Using the arrow keys, select Home Certification.
4 Press ENTER.
Channel Results A symbol indicating whether the channel passed or
failed the overall test.
Table 41 Home Certification Test Results
Name Description
NOTE
Only valid measurements resulting from completed tests are dis-
played. When an error occurs prohibiting a valid measurement, a
dash indicates an invalid numeric value.
NOTE
The limit set parameters you set remain constant for all channel
plans and measurement modes.
21128026 R001 DSAM Help User Guide.book Page 126 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
