Chapter 11 Measure Mode – Sweep Tab
Sweepless Sweep
288 DSAM Help User Guide Rev. 001
Marker Status Area
The Sweepless Sweep measurement mode also contains an area
referred to as the Marker Status area (below the Graph Information
bar). This area consists of the marker name (A or B), marker frequency
(in MHz), and measured signal level for the frequencies which the
markers are on. The black square around the letter A or B indicates
the active marker. The delta label (in dB) and the delta frequency (in
MHz) between the markers is also displayed. The sweep maximum-
minimum dB level (difference between the highest and lowest points
in the sweep graph) is displayed next to the marker status.
Viewing
Sweepless Sweep
Results
To view sweepless sweep results in different ways
1 Press the View softkey.
2 Using the arrow keys, select one of the following:
– Auto Reference (Shift, 9) to automatically view measurement
results in the best reference setting on the graph.
– 1 dB/div, 2 dB/div, 5 dB/div or 10 dB/div – Enables you to
adjust the vertical resolution of the graph for the best viewing.
– Zoom – Turns Zoom on and off.
– Pause (Shift, 8) – Suspends measurement updates.
– Marker A – Sets Marker A as the active marker. (Use the left
and right arrow keys to move the marker.)
– Marker B – Sets Marker B as the active marker. (Use the left
and right arrow keys to move the marker.)
3 Press ENTER.
Saving and
Loading
Reference and
Measurement
Files
When you save a reference, it is automatically appended to the
measurement.
To save and load reference and measurement files
1 Press the File softkey.
NOTE
For best reference setting results you may have to select the Auto
Reference button more than once (up to three times).
21128026 R001 DSAM Help User Guide.book Page 288 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
