Chapter 7 AutoTest Mode
AutoTests Tab
DSAM Help User Guide Rev. 001 119
16 Press the Done softkey.
17 Press the Start softkey.
The AutoTest in Progress screen is displayed, then the results are
displayed.
Figure 110 AutoTest – AutoTest in Progress
NOTE
The Help system is disabled during all tests while they are in prog-
ress.
To stop the Combo Test, press the Stop softkey.
NOTE
To save the results to a file, press the Save softkey then follow
step 4 through step 13 under “Saving Results” on page 198.
If you chose the wrong limit set before conducting the test, press
the Limits softkey and select a different limit set to view your test
results in relation to a different limit set without rerunning the test.
21128026 R001 DSAM Help User Guide.book Page 119 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
