Chapter 5 Configuring the Meter
Configure – Channel Plan Tab
DSAM Help User Guide Rev. 001 79
5 Using the arrow keys, select the plan you want to use for the
network you are servicing.
6 Press ENTER or the Done softkey.
7 Using the arrow keys, select a menu option.
8 Press ENTER.
Each option is described in the following pages.
Editing a Channel
Plan
To edit a channel plan
You can edit an existing channel plan to meet your needs by editing
the channels within the plan. You can change the parameters of indi-
vidual channels or add and delete channels from the plan.
1 Press Configure.
2 Press the Chan Plan softkey.
3 Using the arrow keys, select Downstream Plans.
4 Press ENTER.
5 Using the arrow keys, select a plan.
6 Press the Plan softkey.
7 Using the arrow keys, select Edit.
8 Press ENTER.
NOTE
The plan name is displayed in the title bar for all subsequent
screens until you change plans.
Before you conduct measurements or configure other parameters,
confirm that the correct plan name is displayed in the title bar.
21128026 R001 DSAM Help User Guide.book Page 79 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
