Chapter 9 Measure Mode – Service Tab
DOCSIS
214 DSAM Help User Guide Rev. 001
Selecting a
Different DOCSIS
Channel
To select a different DOCSIS channel
1 Press the Settings softkey.
2 Using the arrow keys, select DOCSIS Channels.
3 Press ENTER.
4 Using the arrow keys, select an option.
5 Press ENTER.
6 Press the OK softkey.
The DOCSIS test automatically runs through the processing steps
again.
Viewing
Registration
Results
During DOCSIS, the meter performs registration and displays the
internet protocol (IP) addresses of the dynamic host configuration
protocol (DHCP), trivial file transfer protocol (TFTP) and time of day
(TOD) servers and gateway. The registration test also provides the
modems internet protocol (IP) address, configuration file, and Service
IDentifier (SID).
To view registration results
1 Press the View softkey.
2 Using the arrow keys, select Register.
3 Press ENTER.
Figure 192 Measure Mode – DOCSIS Registration
21128026 R001 DSAM Help User Guide.book Page 214 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
