JDS Uniphase DSAM-3600 - Changing the Msym;S; Understanding Return QAM Generator Results; Measurement Information Area; Figure 169 Measure Mode - Return QAM Generator

Chapter 8 Measure Mode – Basic Tab
Return QAM Generator
186 DSAM Help User Guide Rev. 001
2 Using the arrow keys, select one of the following:
–CW
–QAM16
–QAM64
3 Press ENTER.
Changing the
Msym/s
To change the Msym/s
1 Press the Settings softkey.
2 Using the arrow keys, select one of the following:
– 1.28 Msym/s
– 2.56 Msym/s
– 3.84 Msym/s
– 5.12 Msym/s
3 Press ENTER.
Understanding
Return QAM
Generator Results
Measurement
Information Area
This area displays information about the current channel. Information
that is displayed in this area includes:
NOTE
The symbol rate is only configurable if you are in a QAM mode.
Figure 169 Measure Mode – Return QAM Generator
21128026 R001 DSAM Help User Guide.book Page 186 Thursday, February 5, 2009 2:02 PM