Chapter 5 Configuring the Meter
Configure – Access Tab
100 DSAM Help User Guide Rev. 001
Table 37 WFA Browser Settings Parameters
Name Description
Preferred Con-
nection
The type of connection. Valid options are Ethernet
and RF. The default value is Ethernet.
Home URL This parameter is “view only” from the DSAM meter.
It is changed via the JDS Uniphase Corporation
Test Productivity Pack (TPP) software. The home
URL address may vary for each network.
Proxy Usage The DSAM allows a proxy server within the Browser
and Web Access Test. A proxy can be used as a
caching mechanism or as a part of a back-end fire-
wall. To enable a proxy server for use with the
Browser mode or Web Access Test, select “Use a
Proxy Server.”
Proxy Server If you have enabled proxy usage, enter the proxy
server IP address. The valid IP address ranges are
0.0.0.0 to 255.255.255.255.
Proxy Port If you have enabled proxy usage, enter the 4-digit
proxy server port number. The default value is
8080.
21128026 R001 DSAM Help User Guide.book Page 100 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
