JDS Uniphase DSAM-3600 User Manual

Chapter 7 AutoTest Mode
AutoTests Tab
134 DSAM Help User Guide Rev. 001
DOCSIS Status View
To view DOCSIS status
1 Using the arrow keys, select the DOCSIS channel you wish to
view.
2 Press the View softkey.
3 Using the arrow keys, select DOCSIS Status.
4 Press ENTER.
Synchronizing Home
Certification Results
with TPP
To synchronize the meter with the JDS Uniphase Corporation Test
Productivity Pack (TPP) software
1 Press the Save softkey.
2 Using the arrow keys and the alphanumeric keypad, type the file
name in the File Name box.
3 Press the Save softkey.
N
NOTE
To save the results to a file, press the Save softkey then follow
step 4 through step 13 under “Saving Results” on page 198.
Figure 128 AutoTest – Home Certification DOCSIS Status
NOTE
Only valid measurements resulting from completed tests are dis-
played. When an error occurs prohibiting a valid measurement, a
dash indicates an invalid numeric value.
21128026 R001 DSAM Help User Guide.book Page 134 Thursday, February 5, 2009 2:02 PM

JDS Uniphase DSAM-3600 Specifications

General

Brand	JDS Uniphase
Model	DSAM-3600
Category	Measuring Instruments
Language	English