Chapter 5 Configuring the Meter
Configure – General Tab
32 DSAM Help User Guide Rev. 001
Battery
Conservation
By configuring the battery conservation parameters for the meter and
backlight shutdown, you can optimize your most recent battery charge
to suit your work practices.
Configuring Battery
Conservation
To configure battery conservation settings
1 Press Configure.
2 Press the General softkey.
3 Using the arrow keys, select Battery Conservation.
4 Press ENTER.
Table 13 Sound Parameters
Name Description
System Sounds The sound level of beeps and other noises made by
the meter. Valid options are Off, Quiet, Medium and
Loud. The default option is Medium.
System Speaker
Level
The sound level of the speaker. Valid options are
one through ten. The default option is nine.
System Micro-
phone Level
The sensitivity of the microphone. Valid options are
one through ten. The default option is four.
NOTE
The factory default time for meter shut off is 10 minutes.
The factory default time for backlight shut off is “always.”
Figure 17 Configure – General Tab: Battery Conservation
21128026 R001 DSAM Help User Guide.book Page 32 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
