Chapter 8 Measure Mode – Basic Tab
MiniScan
158 DSAM Help User Guide Rev. 001
MiniScan
A MiniScan analyzes and displays the carrier levels of up to twelve
channels and displays the results on a single screen. You can view the
results in graph or table form and measure them in relation to pre-
configured limit sets. You can save test results for later reference.
Running a
MiniScan
To run a MiniScan
1 Press Measure.
2 Press the Basic softkey.
3 Using the arrow keys, select MiniScan.
4 Press ENTER.
NOTE
MiniScan measurement channels are user-defined and correspond
to a single Channel Plan. You can select up to twelve channels
within each Channel Plan. See “Configuring Channels for MiniScan”
on page 84 for more information.
If no channels are enabled for MiniScan, an error message is dis-
played.
Figure 145 Measure Mode – Basic Tab
21128026 R001 DSAM Help User Guide.book Page 158 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
