Chapter 7 AutoTest Mode
AutoTests Tab
128 DSAM Help User Guide Rev. 001
14 Press ENTER.
15 Using the arrow keys, select Data Plan.
16 Press ENTER.
17 Using the arrow keys, select an option.
18 Press ENTER.
19 Press the Settings softkey.
20 Using the arrow keys, select the following options.
– Edit Test Point Compensation – See page 71.
– Edit MAC Address – See page 65.
– Edit AutoTest Settings – When the Choose an AutoTest screen
is displayed, use the arrow keys to select one of the following
options then press the Configure softkey.
– Video Channels – See “Configuring AutoTest for Video Chan-
nels” on page 89.
– Cable Modem – See “Configuring AutoTest for Cable Modem”
on page 88.
21 Press ENTER.
22 Press the Done softkey.
23 Press the Start softkey.
The Certification in Progress screen is displayed.
NOTE
Use “Regional Preferences” on page 43 to specify the type of signal
level units and digital performance units you prefer.
Use “Limit Sets” on page 58 to edit limit-set parameters to meet
your needs.
Use “Other Settings” on page 65 to define the best measurement
settings (such as DOCSIS settings) for your current work practices.
21128026 R001 DSAM Help User Guide.book Page 128 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
