Sequencer mode
102
SEQ Page Select
Here's how you can select each page.
• Use the PAGE+/- buttons.
• Press the MENU button to access the page menu, use the
PAGE+/- buttons to select a page, and press the MENU (OK)
button or the ENTER button.
• While the above page menu is displayed, press the FUNCTION
(TABS) button, then use the PAGE+/- buttons to select a page
by its tab, and then press the MENU (OK) button or the ENTER
button.
• Hold down the MENU button and press the PAGE- or PAGE+
buttons.
For details, see “Selecting pages and tabs” on page 12.
.
Page Tab Main content
SEQ
MAIN
Song selection, recording/playback, and tempo
setting (see page 103)
PROG Program selection for each track (see page 105)
MIX
Pan and volume settings etc. for each track (see
page 106)
REC Recording method selection (see page 107)
ARP Simple arpeggiator editing (see page 111)
S–INPUT/
CTRL
AUDIO IN External audio input settings (see page 112)
CONTROLLERS SW1, 2, and tempo settings (see page 112)
S–LOOP/
TONE
LOOP Loop settings for each track (see page 113)
TONE ADJ Tone Adjust editing (see page 114)
EG ADJ EG (ADSR) editing (see page 115)
S–TRACK
MIDI
MIDI channel setting for eack tarck (see page
116)
OSC OSC setting for eack track (see page 116)
PITCH Pitch setting for eack track (see page 117)
SCALE Scale setting for eack track (see page 118)
S–ZONE/
DELAY
KEY ZONE
Key zone and velocity zone (see page 118)
VEL ZONE
DELAY
Time delay from note-on to beginning of sound.
(see page 120)
S–MIDI
FILTER
1, 2, 3, 4
MIDI transmit/receive filter settings. (see page
116)
S–TRACK
EDIT
SELECT TO MEASURE TO
EDIT
Edit operations such as copying or deleting a
track, quantizing, or event editing (see page
124)
S–ARP
ASSIGN
Arpeggiator assignments to each timbre (see
page 125)
A Arpeggiator A settings (see page 126)
B Arpeggiator B settings (see page 126)
SCAN ZONE
Arpeggiator trigger region settings (see page
127)
S–DRUM
TRACK
PATTERN
Drum Track pattern selection and trigger region
settings (see page 127)
CHANNEL
Drum Track input/output MIDI channel settings
(see page 128)
S–STEP
SEQ
BASIC
Step sequencer program selection and length
settings (see page 130)
EDIT Step on/off entry (see page 130)
INST Instrument settings (see page 131)
MOD
Step sequencer settings such as accent and
swing (see page 131)
S–FX
ROUTING
BUS
Bus assignments from each timbre to the insert
effects (see page 132)
SEND
Send amounts from each timbre to the master
effects (see page 132)
IFX
Insert effect type selection and chain settings
(see page 133)
MIXER
Post-insert effect routing settings
(see page 134)
S–IFX IFX1, 2, 3, 4, 5 Insert effect 1–5 settings (see page 134)
S–MFX
SETUP
Master effect type selection and chain settings
(see page 135)
MFX1, 2 Master effect 1 and 2 settings (see page 136)
To Next Page
Loading...
