Korg KROSS - INST (Instrument)

15: P–STEP SEQ (Step Sequencer) 15–3: INST (Instrument)
57
15–3: INST (Instrument)
TONE 01 GROUP/ALL [Kick, ALL]
TONE 02 GROUP/ALL [Snare 1, ALL]
TONE 03 GROUP/ALL [Snare 2, ALL]
TONE 04 GROUP/ALL [H.H Close, ALL]
TONE 05 GROUP/ALL [H.H Open, ALL]
TONE 06 GROUP/ALL [Crash, ALL]
TONE 07 GROUP/ALL [Ride, ALL]
TONE 08 GROUP/ALL [Tom L, ALL]
TONE 09 GROUP/ALL [Tom H, ALL]
TONE 10 GROUP/ALL [Perc 1, ALL]
TONE 11 GROUP/ALL [Perc 2, ALL]
TONE 12 GROUP/ALL [SFX, ALL]
This specifies the type of instruments that can be selected in INST
SELECT. If you select ALL, your choice of any instrument of the
drum kit selected in the P–STEP SEQ> BASIC page can be
assigned to the tone. If you select GROUP, you'll be able to choose
an instrument from the corresponding group of the drum kit.
You can also select a tone by holding down the STEP SEQ
ACTIVE button and pressing one of the pads 1-13.
INST SELECT [Group, All]
Assign an instrument for each tone. This shows the note number
and the name of the drum sample that's assigned by the drum kit to
DS1 of that note. The instruments that you can choose will depend
on the TONE GROUP/ALL setting.
If because of the drum kit's settings there are no instruments in the
corresponding group for a tone, you won't be able to choose INST
SELECT (the screen will indicate “No Items!”). In this case, the
instrument specified for All will be sounded by that tone.
Note: Tone Group settings are made for each instrument (note) of
the drum kit, using the Global mode DRUM KIT> VOICE page
Inst Type parameter.
Tip: You can also use the Assign Inst to Tone function to assign an
instrument.
15–4: MOD (Modulation)
MODULATION CONTROLS
Velocity [-64...+0...+63]
Increases or decreases the velocity values for the entire step
sequencer. The velocity value of each step is specified by the Edit
Step Parameters function.
Swing [-64...+0...+63]
Specifies the amount of swing that is applied to the steps. This
adjusts the timing for the step numbers that are specified by Steps
per Beat for Swing.
Accent [-64...+0...+63]
Increases or decreases the amount of accent for steps whose accent
is turned on.
Values in the range of +01...+63 will raise the velocity for steps
whose accent is on.
Values in the range of -01...-64 will lower the velocity for steps
whose accent is on.