Sequencer mode
112
1: S–INPUT/CTRL (Input/
Controllers)
1–1: AUDIO IN
About the AUDIO IN
The external audio input settings in this page are active when the
front panel REALTIME CONTROLS section AUDIO IN 1 row's
SWITCH (ON/OFF) button is on.
The sequencer does not have tracks for recording audio.
G-SET (Use Global Setting) [Off, On]
Pan [L000...L063, C064, R065...R127]
Select [Line, Mic]
Input Level Meter
Level [000...127]
Mute/Play [Mute, Play]
Gain [00...82, MAX]
Bus (Bus Select) [L/R, IFX1...5, Off]
Send1 [000...127]
Send2 [000...127]
FX Control Bus [Off, FC1, FC2]
These settings are the same as in Program or Global mode.
See “1–1: AUDIO IN” on page 5
1–2: CONTROLLERS
Here you can assign the functions performed by SW1 and SW2.
When you use these buttons during recording, MIDI messages will
be recorded.
Note: The Panel Switch Assign setting of the program assigned to
each track will have no effect.
SW1
Assign [Off, ..., Pich Bend Lock]
This assigns the function of SW1. For more information, please
see the “SW1, SW2 Assign List” section on page 300.
Note: If you change the function setting, the status is reset to off.
Note: If the on/off status of the SW1, SW2 switches is memorized
when you save it.
Mode [Toggle, Momentary]
This specifies the on/off operation when you press the SW1
switch.
Toggle: The function will alternate between on and off each time
you press the SW1 switch.
Momentary: The function will be on only while you continue
holding down the SW1 switch.
SW2
SW2 (SW2 Assign) [Off, ..., Pitch Bend Lock]
Mode (SW2 Mode) [Toggle, Momentary]
This assigns the function of SW2. The functions that can be
assigned to SW2 are the same as for SW1, with the substitution of
SW2 Mod. (CC#81) instead of the SW1’s SW1 Mod. (CC#80).
Tempo
(Tempo) [040.00...300.00, EXT]
This specifies the tempo of the song. This tempo applies to song
playback, arpeggiator, drum track, step sequencer, tempo-synced
LFOs, and tempo-synced effects.
See “ (Tempo)” on page 103
To Next Page
Loading...
