Korg KROSS - ARP (Arpeggiator)

0: COMBI (Combination) 0–4: ARP (Arpeggiator)
73
0–4: ARP (Arpeggiator)
This is the easy edit page for the combination's arpeggiator. A
combination lets you use two arpeggiators simultaneously. For
detailed editing, use the C-ARP page.
You can also control the arpeggiator in real time by using the
KNOB 1 (TEMPO) knob and SWITCH (TAP) button in the
TEMPO row of REALTIME CONTROLS or [GATE],
[VELOCITY], and [SWING].
MOD (Modulation)
[GATE] [–64...+00...+63]
Specifies the length (gate time) of each note in the arpeggio (see
page 51).
[VEL] (Velocity) [–64...+00...+63]
Specifies the velocity of the notes in the arpeggio (see page 51).
[SWING] [–64...+00...+63]
This parameter shifts the timing of the odd-numbered notes of the
arpeggio (see page 52).
A, B (Arpeggiator A, B)
Arpeggiator Run A, B [Off, On]
When the ARP button is on, the arpeggiator(s) you checked here
will run if they are assigned to a timbre by Arpeggiator Assign
(C–ARP> ASSIGN).
When the arpeggiator is on, these check boxes let you turn A and
B on/off.
This parameter can also be set from C–ARP> A, B page
Arpeggiator Run A, B.
Pattern [Preset: UP...Preset: RANDOM, 0000…1279]
Timbre assign
This shows how arpeggiators A and B are assigned to timbres 1–
16. Adjust these settings using Arpeggiator Assign (C–ARP>
ASSIGN).
Octave [1oct, 2oct, 3oct, 4oct]
Resolution [
 ,  ,   ,  ,   ,  ,   ,  ]
Sort [Off, On]
Lat (Latch) [Off, On]
Sync (Key Sync.) [Off, On]
kbd (Keyboard) [Off, On]
Set the various parameters of the combination arpeggiator. For
more information, please see the “6: C–ARP (Arpeggiator)”
section on page 84.
These parameters can also be set from C–ARP pages.
V 0–1...4: FUNCTION
•0: Write Combination, Write/Initialize Combination see page
94
•1: Solo Setting see page 63
•2: Compare see page 64
•3: Auto Song Setup see page 64
•4: Add to Favorite see page 94
•5: Copy from Program see page 95
•6: Hold Balance see page 95 (only MIXER page)
•6: Copy Arpeggiator see page 95 (only ARP page)
For more information, please see the “Combination: FUNCTION”
section on page 94.
Timbre
Assign
PatternRun