Korg KROSS - Eg Adjust

Combination mode
76
2–2: EG ADJUST
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons   to switch
timbres.(see page 71)
Attack (Filter/Amp EG Attack Time) [–99...+99]
This scales the attack times of the Filter and Amp EGs, along with
other related parameters.
When the value is +1 or more, this also affects the Amp EG’s Start
and Attack Levels, Start Level AMS, and Attack Time AMS.
Between values of +1 and +25, the Start Level, Start Level AMS,
and Attack Time AMS will change from their programmed values
to 0. Over the same range, the Attack Level will change from its
programmed value to 99.
Decay (Filter/Amp EG Decay Time) [–99...+99]
This scales the decay and slope times of the Filter and Amp EGs.
Sustain (Filter/Amp EG Sustain Level) [–99...+99]
This scales the sustain levels of the Filter and Amp EGs.
Release (Filter/Amp EG Release Time) [–99...+99]
This scales the release times of the Filter and Amp EGs.
Timbre Info.
Shows the settings of timbres 1–16 for the parameter that you're
editing.
Soloed timbres are indicated by (S).
V 2–1, 2: FUNCTION
•0: Write Combination, Write/Initialize Combination see page
94
•1: Solo Setting see page 63
•2: Compare see page 64
•3: Auto Song Setup see page 64
•4: Add to Favorite see page 94
•5: Copy from Program see page 95
For more information, please see the “Combination: FUNCTION”
section on page 94.