Single size effects 017: Talking Modulator
229
Pre LPF
If a sampler with a very low sampling frequency receives very
high-pitched sound that could not be heard during playback, it
could generate pitch noise that is unrelated to the original sound.
Set “Pre LPF” to On to prevent this noise from being generated.
If you set the “Sampling Fre” to about 3 kHz and set “Pre LPF” to
Off, you can create a sound like a ring modulator.
Resolution [bit]
Output Level
If you set a smaller value for the “Resolution” parameter, the
sound may be distorted. The volume level may also be changed.
Use “Output Level” to adjust the level.
019: St. Analog Record (Stereo
Analog Record)
This effect simulates the noise caused by scratches and dust on
analog records. It also reproduces some of the modulation caused
by a warped turntable.
Flutter
This parameter enables you to set the depth of the modulation
caused by a warped turntable.
Click Level
This parameter enables you to set the level of the click noise that
occurs once every rotation of the turntable. This simulation
reproduces record noise, and the noise generated after the music
on a vinyl record finishes.
Paramter Value Explanation
Spd/RPM Speed 33 1/3, 45, 78
Sets the r.p.m. of a
record
Flutter ← 0...100
Sets the modulation
depth p.229
Noise Dens
Noise
Density
0...100 Sets the noise density
Noise Tone ← 0...100 Sets the noise tone
NoiseLevel Noise Level 0...100 Sets the noise level l
Src Source Off...Tempo
Selects the
modulation source
for the noise level
Amt Amount –100...+100
Sets the modulation
amount of the noise
level
ClickLevel Click Level 0...100
Sets the click noise
level p.229
Src Source Off...Tempo
Selects the modulation
source for the click
noise level
Amt Amount –100...+100
Sets the modulation
amount of the click
noise level
EQ Trim Pre EQ Trim 0...100
Sets the EQ input
level
PEQ F[Hz]
Pre EQ Cutoff
[Hz]
300...10.00k
Sets the EQ center
frequency
Q ← 0.5...10.0
Sets the EQ band
width
Gain [dB] ← –18.0...+18.0 Sets the EQ gain
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Analog Record
Simulation
Pre EQ
Pre EQ
EQ Trim
EQ Trim
To Next Page
Loading...
Need help?
General
