Korg KROSS - Reverb Hall

Effect Guide
276
Tap1 Delay Note
Times
Source
Tap1 Dmod Note
Times
If “Source” is Off or the selected modulation is at 0, the delay time
will be the length specified by “Tap1 Delay Note” and “Times.”
If “Source” is other than Off, the delay time will change so that it
will be as specified by “Tap1 Dmod Note” and “Times” when the
maximum modulation is reached.
Time Over?
You can set the delay time up to 539msec. If the delay time
exceeds this limit, the error message “OVER!” appears in the
display. Set the delay time parameters so that this message will not
appear. “Time Over?” is only a display parameter.
105: Reverb Hall
This hall-type reverb simulates the reverberation of mid-size
concert halls or ensemble halls.
106: Reverb Plate
This plate reverb simulates warm (dense) reverberation.
Pre Delay Thru [%]
“Pre Delay Thru” lets you accentuate the attack by mixing in
sound that does not pass through the delay.
Pan ← L, 1...99, R
Sets the stereo image
of tap2
FB Amt
Feedback
Amount
–100...+100
Sets the Tap2
feedback amount
p.270
Tap3 Lvl Tap3 Level 0...100
Sets the Tap3 output
level
Pan ← L, 1...99, R
Sets the stereo image
of tap3
FB Amt
Feedback
Amount
–100...+100
Sets the Tap3
feedback amount
p.270
Input Trim ← 0...100 Sets the input gain
Pre Tone ← 0...100
Sets the tone of the
input
Wow [Hz
Wow Flutter
[Hz]
0.02...1.00
Sets the frequency-
where pitch variation
will occur
Wow Depth ← 0...100
Sets the depth of
pitch variation
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Paramter Value Explanation
Times[s]
Reverb Time
[s]
0.1...10.0
Sets the reverber-
ation time
HiDamp[%]
High Damp
[%]
0...100
Sets the damping
amount in the high
range
PreEQ Trim Pre EQ Trim 0...100
Sets the EQ input
level
PreDlyThru
Pre Delay
Thru [%]
0...100
Sets the mix ratio of
non-delay sound
Pre LEQ Fc
Low EQ
Frequency
Low,
Mid-Low
Selects the cutoff
frequency (low or
mid-low) of the low-
range equalizer
Pre HEQ Fc
High EQ
Frequency
High,
Mid-High
Selects the cutoff
frequency (high or
mid-high) of the
high-range equalizer
LEQ [dB]
Low EQ Gain
[dB]
–15.0...+15.0
Sets the gain of Low
EQ
HEQ [dB]
High EQ
Gain [dB]
–15.0...+15.0
Sets the gain of High
EQ
Wet/Dry ←
Dry, 1 : 99...
99 : 1, Wet
Sets the balance
between the effect
and the dry input
Src Source Off...Tempo
Selects a modulation
source for Wet/Dry
Amt Amount –100...+100
Sets the modulation
amount for Wet/Dry
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
LEQ HEQ
Pre Delay
Reverb
Pre Delay Thru
Time
Reverb - Hall / Plate Type
Level
Louder
Dry
Reverb
Pre Delay Thru
Pre Delay
Reverb Time