11: P–CMN LFO/KT 11–2: LFO.F (Common LFO Frequency)
43
Reset AMS [List of AMS Sources]
This selects an AMS source to reset the LFO to the Start Phase.
The LFO resets when the AMS value passes the halfway mark:
+50 for most AMS sources, or 64 for MIDI controllers.
To create an effect similar to the per-voice LFO’s Key Sync.
setting, set this to Gate 2+ Damper.
11–2: LFO.F (Common LFO Frequency)
Motion [Nomal, Stop]
Specifies how the Common LFO will function.
Normal: Normal operation. The LFO will function according to
the Frequency and other settings.
Stop: Instead of the LFO operating normally, it will ignore the
Frequency setting. The LFO will maintain the initial value
(determined by the combination of Waveform, Phase, Shape, and
Offset) until the note-off.
Since the value will change only at note-on, using a Random
waveform will produce a fixed value that changes randomly at
each note-on (or at the first note-on).
Frequency Type [Manual, MIDI/Tempo Sync.]
Manual: The Frequency and Frequency Modulation settings
will determine the speed of the LFO, and the tempo settings will
have no effect.
MIDI/Tempo Sync: The LFO will synchronize to the system
tempo, as set by either the tempo or MIDI Clock. The LFO speed
will be controlled by the Base Note and Times parameters below.
All settings for Frequency and Frequency Modulation will be
ignored.
Frequency Type: Manual
Frequency [00...99]
AMS1 (Frequency) [List of AMS Sources]
AMS Intensity [–99...+99]
IntModAMS (Intensity Mod AMS) [List of AMS Sources]
AMS Intensity [–99...+99]
AMS2 (Freq. AMS2) [List of AMS Sources]
AMS Intensity [–99...+99]
The parameters for the Frequency type: Manual are identical to
those for LFO1 “Freqency Type:; Manual.”
For more information, please see page 41
Frequency Type: MIDI/Tempo Sync.
Base Note (Sync. Base Note) [
... ]
Times (Sync. Times) [x1...x32]
The parameters for the Frequency type: MIDI/Tempo Sync. are
identical to those for LFO1 “Freqency Type:; MIDI/Tempo Sync.”
For more information, please see page 41
AMS Intensity